Konica Minolta bizhub C25 - Manual (Page 472)

Configuring the Printer 9-185
[Access Refuse
Address] If [Enable] is selected, the range of IP addresses refused
access to the printer can be specified.
A maximum of five ranges of refused IP addresses can be
specified.
If [Disable] is selected, the refused access setting is
disabled.
Choices: [Enable], [Disable]
Default: [Disable]
Configuration Menu Equivalent:
[UTILITY] - [ADMIN. MANAGEMENT] - [NETWORK
SETTING] - [IP ADDR. FILTER] - [ACCESS REFUSE]
[Range of IP
address refused
access*] Specify the range of IP addresses refused access to the
printer. Type the IP address at the beginning of the range
into the box on the left, and the IP address at the end of
the range into the box on the right.
Range: 0-255 for each xxx triplet
Default: [0.0.0.0]
d
To specify a single IP address, type the same IP
address into both the box for the starting IP
address and for the ending IP address, or type
[0.0.0.0] into the box for either the starting IP
address or the ending IP address.
d
If the starting IP address is larger than the ending
IP address, the setting is not applied.
[Apply] button Applies the configuration settings in this page.
[Clear] button Resets all configuration settings to previous values.
* Always enter these addresses without leading zeros. For example,
131.011.010.001 should be entered as 131.11.10.1.
Item Description