Konica Minolta Printgroove - Manual (Page 24)

Configuring Printgroove POD Queue 3
Printgroove POD Queue 3-3
3.2.2 Server/Client Compatibility Verification
1
After authentication is verified, the Printgroove POD Queue client will
broadcast the current client version information and check to see if it is
compatible with the installed version of the Printgroove POD server.
If the versions are incompatible, a screen opens to notify you of this sit-
uation.
2
Click the [OK] button to close the notification screen.
3
Click the [Cancel] button on the Log In screen and inform your System
Administrator of the situation. Log In will not be allowed until this situ-
ation is resolved.
If the versions are compatible, the Main screen opens.
Once you have successfully logged in, several situations may cause Print-
groove POD Queue to close. Please note the following:
-
If the Printgroove POD Server is powered down
- If server maintenance is initiated
- If the security key attached to the Printgroove POD Server is removed
In all three cases, an error message will inform you of the condition. Click the
[OK] button on the pop-up screen to close the message. Printgroove POD
Queue will then shut down. Check with your System Administrator if these
situations occur and you have questions.