Environmental variables 43, Lparm:pcl fontnumber, Lparm:pcl fontsource – Konica Minolta Magicolor 2350EN User Manual
Page 47: Lparm:pcl linetermination
Environmental Variables
43
Variable
LPARM:PCL FONTNUMBER
Choices/
Range
0-65535(dependent on FONTSOURCE and
SYMSET--see note)
Default
0
Description Selects the PCL font to be used for the current job. This
variable is used with the FONTSOURCE variable to identify
the specific font to be used.
Font numbers start at 0 if a font is set as default;
otherwise, font numbering starts at 1.
The recommended order of setting the variables affecting
the font is SYMSET, FONTSOURCE, and then
FONTNUMBER.
Variable
LPARM:PCL FONTSOURCE
Choices/
Range
I
S
Default
I
Description This variable identifies the source of the fonts to be used.
I — Internal Fonts
S — Permanent Soft Fonts
Variable
LPARM:PCL LINETERMINATION
Choices/
Range
0
1
2
3
Default
2
Description Sets the line termination value.
0—CR=CR, LF=LF, FF=FF
1—CR=CR-LF, LF=LF, FF=FF
2—CR=CR, LF=CR-LF, FF=CR-FF
3—CR=CR-LF, LF=CR-LF, FF=CR-FF