ABC Office CR-2032 - Manual (Page 51)

45
Z1 and Z2 COUNTER PRESET
Z1 and Z2 COUNTER PRESET
Z1: Represents the End-of-Day reading (resets totals to "0").
Z2: Represents the End-of-Week/Month reading (resets totals to "0").
Allows you to select the beginning number for the Z1 Counter. The "Z" Counter is programmed by the factory to
count up consecutively after each "Z" reading. It provides a tally of the number of "Z" readings from the first "Z"
reading taken on the cash register to the present. In the event a Full System Clear procedure is performed (which
resets all data to zero), the "Z" Counter Preset feature will also allow you to re-enter the previous "Z" Counter
Number.
TO PROGRAM THE Z1 COUNTER NUMBER
"PRG" + (1) + (Z1 COUNTER #) + [RETURN]
4 digit #
Example: To program the Z1 Counter for the number 0050:
1.
Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (1), (0050), then PRESS the [RETURN] key.
TO PROGRAM THE Z2 COUNTER NUMBER
"PRG" + (2) + (Z2 COUNTER #) + [RETURN]
4 digit #
Example: To program the Z2 Counter for the number 0100:
1.
Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (2), (0100), then PRESS the [RETURN] key.
abcoffice
www.abcoffice.com 1-800-658-8788