AEG BS7304021M - Manual (Page 44)

8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water
and soap. Dry the glass panel care-
fully.
Installing the door and the
glass panels
When the cleaning is completed, install
the glass panels and the oven door. Do
the above steps in the opposite se-
quence. Install the smaller panel first,
then the larger.
13. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does
not heat up. The appliance is deactiva-
ted. Activate the appliance.
The appliance does
not heat up. The clock is not set. Set the clock.
The appliance does
not heat up. The necessary settings are
not set. Check the settings.
The appliance does
not heat up. The Child Lock is activated. Refer to "Activating and
deactivating the Child Lock
function".
The appliance does
not heat up. The fuse is released. Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
The display shows
F111. The CT Sensor plug is not
correctly installed into the
socket. Put the plug of core tem-
perature sensor as far as
possible into the socket.
The lamp does not
operate. The lamp is defective. Replace the lamp.
The lamp does not
operate. You have selected an ECO
function or Moist Fan Bak-
ing . In these functions the
light cannot be activated. The light cannot be activa-
ted because these func-
tions help to save energy.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre. The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavi-
ty.
44 www.aeg.com