American Panel HURRICHILL AP120BCF1300-3 - Manual (Page 24)

AP120BC1000-3/ AP120BCF1300-3 Manual
23
HEATED PROBE CYCLE PARAMETERS PROGRAMMING
After about 2 seconds the display will automatically
change to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
dd. Press the button. The LED for "HEATED
PROBE" will be steady "ON".
ee. To change the temperature, press or
then press .
30 Blinks
ff. To change the time, press or then
press .
05 Blinks
The display will show:
After about 2 seconds the display will automatically
change to:
The LED for "A" will be "ON".
The LED'S for cycles will be blinking.
gg. Press to program the manual mode. The
"M" LED will be steady "ON" and the 6 "CYCLE
LED's" will all blink.
MANUAL SOFT CYCLE PARAMETERS PROGRAMMING
hh. Press . The LED for "SOFT" will be steady
"ON".
ii. To change the temperature, press or
then press .
28 Blinks
jj. To change the temperature, press or
then press .
35 Blinks
PARAM. PROGRAMMING
MANUAL MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGRAMMING
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE
PARAM. PROGRAMMING
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
HIGH AIR TEMPERATURE
35 °F
PARAM. PROGRAMMING
MANUAL SOFT CYCLE
LOW AIR TEMPERATURE
28 °F
PARAM. PROGRAMMING
HEATED PROBE CYCLE
HEATING TEMPERATURE
30 °F
PARAM. PROGRAMMING
HEATED PROBE CYCLE
PROGRAMMING COMPLETE
PARAM. PROGRAMMING
HEATED PROBE CYCLE
HEATING TIME
05 SEC
AUTOMATIC MODE
CHOOSE
PROGRAMMING CYCLE