Bizfon 4000 - Manual (Page 22)

Bizfon Manual I: Installation Guide Step 2.3 Internet Configuration Wizard
Step 2.3: Internet Configuration Wizard
Open the Internet Configuration Wizard by selecting the corresponding menu item on the
System menu. The Internet Configuration Wizard is a tool for the administrator to config-
ure the WAN settings and to adjust Bizfon's connectivity in the global network. It must be
run if Bizfon is desired to be connected to the Internet.
The page Getting Started will be displayed:
Fig. I-18: Internet Configuration Wizard
This first page of the Internet Configuration Wizard is for informational purposes only and
lists the items to be configured, Click on the Next button for the Uplink Configuration
page.
Before configuring the WAN port to the Internet, you need to get the following information
from your internet service provider:
•
Bandwidth - how much is available upstream and downstream?
•
WAN IP Configuration - is DHCP supported? If yes, no more information is needed. If
DHCP is not supported, the following data is needed: the WAN IP address, the sub-
net mask, the IP address of the standard gateway and the IP address of the Domain
Name Server (DNS).
•
MAC address - needed when the ISP requires a specific MAC address for the WAN.
•
MSCHAP) is needed in-
cluding the username and password of the PPPoE account.
Additionally, for Point-to-Point Protocol over Ethernet (PPPoE) WAN interface, you need to
et the following information from your internet service provider: g
•
PPP Configuration - does your ISP use a dynamic or fixed WAN IP address? If the
WAN IP address is dynamic, no more information is needed. If the WAN IP address
is fixed, you will have to enter it.
Authentication - does your ISP require authentication? If authentication is required,
information about the corresponding method (PAP, CHAP or
Bizfon2000 and Bizfon4000 (SW Version 3.1.x) 22