Pioneer VSX-921 - Manual (Page 21)

En 21
03 Connecting your equipment
% Switch the receiver into standby then
use the supplied iPod cable to connect
your iPod to the iPod iPhone iPad USB
terminal on the front panel of this
receiver.
! It is also possible to connect using the cable
included with the iPod, but in this case it is not
possible to view pictures via the receiver.
! For the cable connection, also refer to the
operating instructions for your iPod.
! For instructions on playing the iPod, see
Playing an iPod on page 27 .
Connecting a USB device
It is possible to play audio and photo files by
connecting USB devices to this receiver. It
is also possible to connect a USB keyboard
(US-international layout) to the receiver to enter
text in the following GUI screens.
! Change the input name in the Input Setup
menu (page 24).
! Add names to radio station presets (page 30).
CONTROL ON / OFF
MCACC
SETUP MIC
iPod
iPhone
iPad
USB
5V 2.1 A
HDMI 2 INPUT
USB mass
storage device
USB keyboard
% Switch the receiver into standby
then connect your USB device to the
USB terminal on the front panel of this
receiver.
! This receiver does not support a USB hub.
! For instructions on playing the USB device,
see Playing a USB device on page 28 .
Connecting an HDMI-equipped
component to the front panel
input
VSX-1021 only
MCACC
SETUP MIC
iPod
iPhone
iPad
USB
5V 2.1 A
HDMI 2 INPUT
Video camera (etc.)
CONTROL ON / OFF
Connecting to the front panel
video terminal
VSX-921 only
Front VIDEO 2 connections are accessed via
the front panel using the INPUT SELECTOR
or INPUT SELECT
c/d button on the remote
control. There are standard audio/video jacks.
Hook them up the same way you made the rear
panel connections.
MCACC SETUP MIC L AUDIO R VIDEO
VIDEO 2 INPUT
iPod iPhone iPad USB
5V 2.1 A
CONTROL ON / OFF
L VIDEO R
AUDIO/VIDEO OUTPUT
Video camera
(etc.)
Connecting to a wireless LAN
Wireless connection to the network is possible
through a wireless LAN connection. Use the
separately sold AS-WL300 for connection.
! For instructions on setting the wireless LAN
converter, see Network Setup menu on page
64 .
WAN
DC 5V WPS Ethernet
UNBAL
FRONT CENTER SURROUND R L R
AM LOOP
( CD ) ( DVD )
COAXIAL
PRE OUT SPEA
TENNA
ASSIGNABL OUT
SUBWOOFER
IN 1 IN 2
CAUTION:
SPEAKER IMPEDANCE 6 -16 .
ATTENTION:
ENCEINTE D’IMPEDANCE DE 6 -16 .
A
DC OUTPUT
for WIRELESS LAN
(OUTPUT 5 V 0.1 A MAX)
ADAPTER PORT
(OUTPUT 5 V 0.6 A MAX)
(10/100) LAN
Internet
Modem
Wireless LAN converter (AS-WL300)
Router
Connecting an IR receiver
If you keep your stereo components in a closed
cabinet or shelving unit, or you wish to use the
sub zone remote control in another zone, you
can use an optional IR receiver (such as a Niles
or Xantech unit) to control your system instead
of the remote sensor on the front panel of this
receiver.
! Remote operation may not be possible if direct
light from a strong fluorescent lamp is shining
on the IR receiver remote sensor window.
! Note that other manufacturers may not use
the IR terminology. Refer to the manual that
came with your component to check for IR
compatibility.
! If using two remote controls (at the same
time), the IR receiver’s remote sensor takes
priority over the remote sensor on the front
panel.