Pioneer VSX-921 - Manual (Page 67)

En 67
12 The System Setup and Other Setup menus
Important
! DO NOT unplug the power cord during
updating.
! When updating via the Internet, do not
disconnect the LAN cable. When updating via
a USB memory device, do not disconnect the
USB memory device.
1 Select ‘Software Update’ from the
Other Setup menu.
2 Select the update procedure.
! Update via Internet – The receiver checks
whether updatable software is available via
the Internet.
! Update via USB Memory – The receiver
checks whether the USB memory device
inserted into the USB port on the receiver’s
front panel contains updatable software.
“Accessing” is displayed and the update file
is checked. Wait a while.
3 Check on the screen whether or not an
update file was found.
If “New version found.” is displayed, the
update file has been found. The version number
and updating time are displayed.
If “This is the latest version. There is no need
to update.” is displayed, no update file has
been found.
4 To update, select OK.
The updating screen appears and updating is
performed.
! The power turns off automatically once
updating is completed.
Software Update messages
Status
messages
Descriptions
NO UPDATE
FILE
No update file was found on the
USB memory device. Store the file
in the USB memory device’s root
directory.
FILE ERROR
Try disconnecting then reconnecting
the USB device or storing the update
file again. If the error still occurs,
try using a different USB memory
device.
UPDATE
ERROR 1
to UPDATE
ERROR 7
Turn the receiver’s power off, then
turn it back on and try updating the
software again.
Update via
USB
If this message flashes, updating
has failed. Update via a USB mem-
ory device. Put the update file on a
USB memory device and connect
the device to the USB port. When
the file is found, software updating
starts automatically.
UE11
Updating has failed. Use the same
procedure to update the software
again.
UE22
UE33