Pioneer PDP-SX5080D - Manual (Page 18)

Preparation 05
18
En
Basic connections
Connecting the antenna
To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Caution
• When the “Aerial Power” setting is on, directly connect the
aerial to the ANT input terminal at the rear of the plasma
television. Connecting any device between the aerial and
plasma television may cause damage to the device.
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
• If “Aerial Power” setting is enabled, use an indoor antenna with
signal amplifier, 5 V 30 mA.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the plasma television.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.
Routing cables
When the speaker is installed under the plasma television panel (for
PDP-5080XD/PDP-SX5080D only):
Note
• Use the supplied bead bands as necessary.
• When tidying up your speaker cables, make sure to bundle them
so that they are not subjected to any pressure.
Attaching speed clamps to the main unit
Use the speed clamps as necessary to route the connecting cables.
The diagrams below show the location of the holes on the rear of the
plasma television.
(PDP-5080XD/PDP-SX5080D)
(PDP-4280XD/PDP-SX4280D)
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
Rear view
Speaker cable
Bead band
Rear view