Pioneer XW-SMA3-W - Manual (Page 24)

Connect to network 04
24
En
E: Connection settings using an iOS device
If you use an iPhone/iPod touch/iPad (iOS device with iOS 5.0
or later) with wireless LAN connection, apply the iOS device’s
connecting settings to this unit.
1 Confirm that the AC adapter and LAN cable
are not connected to the unit.
2 Connect the AC adapter, and press
 standby/on button.
The on indicator will flash blue. Wait for about 30 to 40
seconds.
3 When the on indicator stops flashing, use
the Dock Connector to USB Cable to connect this
unit to the iPod touch/iPhone/iPad (iOS device
with iOS 5.0 or later).
4 Press and hold input button on the front
panel, and then press and hold network setup/
wireless direct button on the rear panel for 3
seconds.
A screen like the following should appear on the iOS device.
5 Tap the “Allow” button.
6 When the network indicator changes from
flashing red to steadily lighted blue, the
connection is completed.
• Confirm that the iOS device has a wireless connection to
your router.
• Confirm that the iOS device’s screen lock is disabled.
AUX IN DC IN iPod/iPhone/iPad LAN(10/100)
AUX IN DC IN
input volume standby/on
6
iPod/iPhone/iPad LAN(10/100)
network setup
wireless direct
AUX IN DC IN
input volume standby/on
6
on input network
blue