Pioneer XW-SMA3-W - Manual (Page 39)

Additional information 09
39
En
Wireless LAN
Problem Check Remedy
Network cannot be accessed
via wireless LAN. The computer may determine the presence/absence of a wireless
LAN in accordance with the presence/absence of the cable at the
time the unit’s power is turned on. When using a wireless LAN,
disconnect the LAN cable from this unit and then turn the unit OFF
and ON again.
This unit and base unit (wireless LAN
router, etc.) are too far apart or there
is an obstacle between them. Improve the wireless LAN environment by moving the unit and
base unit closer together, etc.
There is a microwave oven or other
device generating electromagnetic
waves near the wireless LAN
environment. Use the system in a place away from microwave ovens or others
device generating electromagnetic waves.
Avoid using devices generating electromagnetic waves as much as
possible when using the system with the wireless LAN.
Wireless LAN connections cannot be
established between the unit and
base unit (wireless LAN router, etc.). The unit must be set in order to establish wireless LAN
connections. See Connecting using wireless LAN on page 12.
The IP address settings of the unit
does not match the settings of the
wireless LAN router, etc. Check the IP address settings of the unit (including the DHCP
setting).
If the unit’s DHCP setting is on, turn the unit’s power off, then turn
the power back on.
Check that the IP addresses of the unit match the settings of the
wireless LAN router, etc.
If the unit’s DHCP setting is off, set an IP address matching the
network of the base unit (wireless LAN router, etc.).
For example, if the wireless LAN router’s IP address is
“192.168.1.1”, set the unit’s IP address to “192.168.1.XXX” (*1), the
subnet mask to “255.255.255.0”, the gateway and DNS to
“192.168.1.1”.
(*1) Set the “XXX” in “192.168.1.XXX” to a number between 2 and
248 that is not assigned to other devices.
The access point is set to conceal the
SSID. In this case, the SSID may not be displayed on the access point list
screen. If not, set the SSID, etc., by making the wireless LAN
settings on the unit manually.
The SSID only supports use of single-byte alphanumeric characters,
together with the underbar and certain other symbols. If using
another character coding, the SSID must be updated before making
network settings. For more details regarding SSID, consult your
router's operating instructions.
The access point’s security settings
use WEP 152-bit length code key or
shared key authentication. The unit does not support WEP 152-bit length code key or shared
key authentication.
It may be that the router has frozen. Press the router’s reset button
and try making the settings again.
Doesn’t play properly when
using the Wireless Direct
function. The Wireless Direct function may not operate properly depending
on the condition of signal reception and the wireless LAN device
connected. In such cases, bring the wireless devices closer
together and in other ways improve the conditions for wireless
LAN’ reception.