Pioneer VSX-909RDS - Manual (Page 10)

10
En
Operating range of remote control unit
The area in which you can use the remote control to operate
the VSX-909RDS/909RDS-G is fairly large. To use, point the
remote control toward the remote sensor on the front panel of
this unit while within the range shown right.
Remote control may not function properly if:
• There are obstacles between the remote control and the
remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver located near a device emitting infrared rays.
• Operated simultaneously with another remote control which
uses infrared rays.
30
°
30
°
7m
Before You Start
memo
OUT
IN
CONTROL
OUT
IN
CONTROL
PIONEER component
bearing the
Î mark.
Remote Control
To CONTROL IN
terminal of another
PIONEER component
bearing the
Î mark.
Receiver
• You can also control PIONEER components (and those made by other manufacturers) by pointing the
receiver’s remote control directly at the respective components. This type of operation does not require
control cords. All you have to do is recall the appropriate preset code (refer to “Recalling preset
codes” on page 65).
• If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able
to use this unit's remote control.
Operating other PIONEER components
Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the
receiver’s remote control at the remote sensor on the front panel of the receiver. The receiver then sends the
remote control signals to the other components via the CONTROL OUT terminal.