Set up multi channel in setting, 1 use the 5¥∞ buttons to select multi channel in, 3 use the 5¥∞ buttons to select exit – Pioneer VSX-909RDS User Manual
Page 41: Multi channel in setting using the main unit, Initial set up, Multi ch input standby/on, The default setting is bypass
41
En
SET
UP
Multi Channel In Setting
If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, in
which case only the main volume can be controlled, or to ADJUST, which means the levels can be reduced in
volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in “Setting
Up for Surround Sound“ (p.30) first.
1 Use the
5¥∞ buttons to select MULTI
CHANNEL IN.
See “Setting Up for Surround Sound“ on page 30 if you need
more information.
Press the ENTER button.
This information will be displayed on your TV.
Multi channel in
Select mode
[
Channel Level
]
[EXIT]
[BYPASS]
2 Use the
2¥3 buttons to select the setting
you want, BYPASS or ADJUST.
ADJUST: Use the ADJUST setting when you want to be able
to control each channel level individually.
BYPASS: This setting is good for getting the cleanest possible
signal. In this setting you won’t be able to change each channel
individually.
We recommend using BYPASS and the default setting is
BYPASS.
3 Use the
5¥∞ buttons to select EXIT.
Press the ENTER button.
You wil return to the SYTEM SETUP mode.
Multi Channel In Setting Using the Main Unit
You can also use the main unit to change the sound level of the MULTI CH IN. Folow the step below.
1 Put receiver in the STANDBY mode.
2 While holding down the MULTI CH
INPUT button press the
STANDBY/ON button.
The setting will change depending on what state
the receiver was previously in. For a few seconds
the display will show you which MULTI CH setting
you are now in.
MULTI CH INPUT
STANDBY/ON
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
1-3
/DTS/MPEG
S0URCE
DVD/LD
TV/SAT
VCR1
VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO/
DIRECT
DSP
THX
LIGHT
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TVCONT
RECEIVER
USE
SETUP
MULTI
OPERATION
CLASS
MPX
DIRECT ACCESS
CHANNEL
STATION
TUNING
DISPLAY
RF ATT
TV CONTROL
FUNCTION
REMOTE SETUP
SYSTEM SETUP
INPUT
ATT
ADVANCED
MIDNIGHT
MULTI CH
INPUT
STANDARD
DIGITAL
NR
EFFECT/
CH SEL
SIGNAL
SELECT
BAND
SYSTEM
OFF
1
2
3
4
5
6
7
8
9
0
DISC
Î
¶
8
7
3
1
¡
4
¢
+
-
+
-
+
-
MULTI CONTROL
+
+
–
–
+
–
+10
Initial Set Up
memo
The default setting is BYPASS.