Pioneer VSX-909RDS - Manual (Page 47)

OPERA
TION
47
En
Basic Playback
Playing Stereo Sources
The following instructions show you how to use the receiver for stereo audio or audio-visual.
If the TAPE 2 indicator is visible in the display, it means the TAPE 2 MONITOR is on. Press TAPE 2
MONITOR on the front panel to turn it off unless you want to listen to TAPE 2.
1 Turn on the power of the playback
component.
2 Put the remote control slide switch in USE.
3 Press the RECEIVER button to turn on
the receiver.
Be sure that the standby indicator turns off on the front
panel.
4 Press the MULTI CONTROL buttons or the
FUNCTION button to select the source you
want to playback.
The FUNCTION button cycles through the sources in the
following order:
5 Press the STEREO/DIRECT button to select
the stereo mode.
The STEREO indicator lights on the display.
6 Press the SIGNAL SELECT button to select
the input signal corresponding to the
source component.
(See “Switching Analog and Digital Signal Input” on page 48.)
7 Start playback of the component you
selected in step 1.
8 Adjust the volume by using the VOLUME
buttons on the remote control or the
MASTER VOLUME on the front panel.
If you are not able to get sound from the receiver the
problem may well lie with the SIGNAL SELECT switch.
You need to make sure the input is set to the appropriate
ANALOG or DIGITAL setting. Refer to page 48 for more
on this.
memo
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
2
3
4
6
5
4
8
/DTS/MPEG
S0URCE
DVD/LD TV/SAT VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO/
DIRECT DSP
THX LIGHT
MUTE
TV
VOLUME
MD/
TAPE1 TUNER TVCONT
RECEIVER
USE SETUP
MULTI
OPERATION
CLASS MPX DIRECT ACCESS
CHANNEL
STATION TUNING
DISPLAY RF ATT
TV CONTROL
FUNCTION
REMOTE SETUP
SYSTEM SETUP
INPUT
ATT
ADVANCED
MIDNIGHT MULTI CH
INPUT
STANDARD
DIGITAL
NR
EFFECT/ CH SEL
SIGNAL SELECT
BAND
SYSTEM
OFF
1 2 3
4 5 6
7 8 9
0
DISC
Î
¶ 8 7 3
1 ¡ 4 ¢
+ -
+ -
+ -
MULTI CONTROL
+ +
– –
+
–
+10
3 4 6
8
5
_ON/—OFF
button
memo
TUNER MD
VCR 2 VCR 1
TV/SAT DVD/LD
VIDEO
CD
PHONO
Before operating the receiver, be sure to press the
_ ON/ — OFF button on the front panel to turn the
power ON ( _).