Pioneer VSX-909RDS - Manual (Page 68)

68
En
5 Press the button to be programmed.
The MULTI CONTROL button lights steadily.
• The TV POWER, TV FUNC and TV VOL +/– buttons are only
available for learning when programming TV CONTROL
operations.
6 Point the remote controls at each other and
press the button on the other remote
control for the operation you wish to
program .
5–20 cm
1 Point the remote controls toward each other.
2 Hold down the button on the other remote control corre-
sponding to the operation you wish to program. Release
when the MULTI CONTROL button on the receiver's remote
control starts blinking.
(The MULTI CONTROL button blinks to indicate that the
operation has been learned.)
To program additional operations for the current
component, repeat steps 5 and 6.
To program operations for another component, repeat
steps 4 through 6.
7 Press the REMOTE SETUP button to exit the
learning setup mode.
The remote control and TV return to their previous operation
modes.
• When you're done setting up, remember to set the slide
switch back to USE.
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/DTS/MPEG
S0URCE
DVD/LD TV/SAT VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO/
DIRECT DSP
THX LIGHT
MUTE
TV
VOLUME
MD/
TAPE1 TUNER TVCONT
RECEIVER
USE SETUP
MULTI
OPERATION
CLASS MPX DIRECT ACCESS
CHANNEL
STATION TUNING
DISPLAY RF ATT
TV CONTROL
FUNCTION
REMOTE SETUP
SYSTEM SETUP
INPUT
ATT
ADVANCED
MIDNIGHT MULTI CH
INPUT
STANDARD
DIGITAL NR
EFFECT/
CH SEL
SIGNAL SELECT
BAND
SYSTEM
OFF
1 2 3
4 5 6
7 8 9
0
DISC
Î
¶ 8 7 3
1 ¡ 4 ¢
+ -
+ -
+ -
MULTI CONTROL
+ +
– –
+
–
+10
5
7
Remote Control of Other Components