Pioneer X-HM30DAB-K - Manual (Page 12)

X-HM30V_DAB_En.fm
En-12
2011August 30
8
7
6
5
4
3
2
1
System Connection (continued)
This will allow you to play the sound from the TV‘s built-in
tuner.
l Connect the audio output on your TV to the LINE IN on
this receiver.
Use an audio cable.
To select Line In function:
l On main unit: Press INPUT button repeatedly until
Line In is displayed.
l On remote control: Press LINE button.
Remote control
WARNNIG:
l Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.
Caution:
l Replace all old batteries with new ones at the same
time.
l Do not mix old and new batteries.
l Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
l Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
l Installing the batteries incorrectly may cause the unit to
malfunction.
Notes concerning use:
l Replace the batteries if the operating distance is
reduced or if the operation becomes erratic. Purchase
2 “AAA” size batteries.
l Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
l Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
l Keep the remote control away from moisture, heat,
shock, and vibrations.
l When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
Check the remote control after checking all the
connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:
n Connect your TV (For TV audio)
AUX LINE
S-VIDEO HDMI
COMPONENT VIDEO
COAXIAL
AC IN
4
A
ud
io si
gnal
TV To audio
output sockets
Audio cable
(commercially
available)
Main unit
To LINE
input
sockets
n Battery installation
1 Open the battery cover.
2 Insert the supplied batteries according to the direction
indicated in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3 Close the cover.
n Test of the remote control
MEMORY/FOLDER
STANDBY/ON
7 m
Remote sensor