Pioneer X-HM30DAB-K - Manual (Page 20)

X-HM30V_DAB_En.fm
En-20
2011August 30
8
7
6
5
4
3
2
1
Listening to the iPod, iPhone or iPad (continued)
l Sound will only switch from iPhone to the main unit
after authentication process is completed in
approximately 10 seconds.
l Incoming calls will pause the playback.
l Once the calls are answered, the conversation can
only be heard through the built-in iPhone speaker. Turn
on the iPhone speaker or undock the iPhone to start
conversation.
Simply remove the iPod or iPhone from the the docking
station or iPad from USB terminal. It is safe to do so even
during playback.
Notes:
l If the TV Out setting is already turned on at video
menu, the video is automatically displayed on the TV
screen when ENTER key is pressed.
l TV out display is not support through USB terminal.
(iPad)
l To return to watching video on iPod or iPhone screen,
press the ENTER button to enter video menu. Then
press the OSD/TV OUT button for more than 2
seconds until “iPod Display” appears.
l During iPod or iPhone video playback, pressing the
OSD/TV OUT button will not toggle video out display
between iPod and TV.
Caution:
l The video images from the iPod and iPhone will only be
output from the VIDEO OUT terminal. They will not be
output from the S-VIDEO OUT, COMPONENT VIDEO
OUT, and the HDMI OUT terminals.
l Unplug all accessories for the iPod or iPhone before
inserting it into the iPod docking station.
l Stop button () at main unit is invalid during iPod
function.
Note:
When navigating the iPod, iPhone or iPad menu with remote
control, do not operate any of the buttons on the iPod or iPhone
unit. The volume level is adjusted by pressing the VOL (+ or –)
button on the main unit or the remote control. Adjusting the
volume on the iPod, iPhone or iPad units give no effect.
iPod and iPhone operations:
The operations described below depend on the generation
iPod and iPhone you are using.
System on operation:
When the main unit is powered on, iPod, iPhone or iPad units will
automatically power on when docked in the unit.
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked iPod,
iPhone or connected iPad unit will automatically turn to stand-by
mode.
n To remove adaptor for iPod or iPhone
(Docking Station)
Insert the tip of a screwdriver (“–” type,
small) into the adaptor hole as shown
and lift upward to remove.
n iPod or iPhone playback
1 Press the STANDBY/ON button to turn the power on.
2 Press the iPod/iPhone button on the remote control or
INPUT button repeatedly on the main unit to select
iPod function.
3 Insert iPod or iPhone unit in iPod dock of main unit.
"Dock Ok" will appear.
4 Press the  button to start playback.
n iPhone playback
n To disconnect iPod, iPhone or iPad
MEMORY/FOLDER
+
DVD/CD
TUNER/DAB
SCAN ENTER(DAB) DISPLAY
INPUT
STANDBY/ON
STANDBY/ON
OSD/TV OUT
ENTER
PRESET PRESET
iPod/iPhone
n Watching videos on a TV connected to
iPod or iPhone (Docking Station)
1 Press the OSD/TV OUT button for more than 2
seconds. “TV Display” will appear on display.
2 Press the ENTER button to start playback.
n Navigating the iPod, iPhone or iPad
menus
1 Press the TOP MENU button to view the menu on iPod,
iPhone or iPad unit. Press it again to go back to previous
menu.
2 Use the  or  button to select an item on the menu
and then press ENTER button.