Pioneer X-HM30DAB-K - Manual (Page 40)

X-HM30V_DAB_En.fm
En-40
2011August 30
8
7
6
5
4
3
2
1
Listening to the DAB+ (continued)
After the scan:
The stations will be stored in alphanumeric order and the
first station on the list will be selected and you will hear it
through the speakers.
l To listen to other stations, see "Selecting a station in
the station list" on page 40.
Notes:
l If no station is found, "NO Service" appears.
l Up to 99 appears for total received stations.
Once a DAB+ station is received, you can select stations
in the station list.
1 Press the TUNER/DAB button until "DAB" appears on
the display.
2 Whilst receiving a DAB+ station, press the TUNING +
or – to select the desired station.
3 Within 10 seconds, press the DAB ENTER button on
the remote control to tune into the desired station.
You can manually store stations which Auto Scan cannot
find. If reception is poor, you can adjust the sensitivity.
Manual tune is only available after Auto tune. Perform Auto
Scan first.
1 Press the TUNER/DAB button until "DAB" appears on
the display.
2 Press the DAB SCAN button once.
3 Within 10 seconds, press the TUNING + or – to select
the DAB+ frequency.
4 Within 10 seconds, press the DAB ENTER button.
l Reception sensitivity appears.
l If the level is too low, move the aerial or unit to
improve reception.
5 Press the DAB ENTER button again to store the station
and exit manual tune.
You can switch DAB+ display information.
Press the DAB DISPLAY button.
Each time the button is pressed, the information display
changes in the following order.
When "No Service" appears, the DAB DISPLAY button
does not allow you to change the display.
[Station Name]
Station name is displayed. (set by default)
[Scrolling text]
Information scrolls across the display when sent from the
station.
[Programme type]
A description of the type of content being broadcast by the
station.
[Multiplex name]
The name of the multiplex (ensemble) which provides the
current service.
[Channel/Frequency]
The DAB+ channel and frequency for the station.
(Frequency is displayed to two decimal places)
[Mode]
The data transfer speed and channel type appear.
[Signal quality]
The signal quality is displayed as a number (0 - 100).
[85-100: Good, 70-84: Fair, 0-69: Poor]
You can store 40 DAB stations in memory and recall them
at the push of a button. (Preset tuning)
1 Tune to the desired DAB station.
2 Press the MEMORY station.
3 Within 30 seconds, press the PRESET + or – button to
select the preset channel number. Store the stations in
memory, in order, starting with preset channel 1.
n Selecting a station in the station list
n Manual tune
+
+
Display current station
The name of the station
being selected
+
+
+
+
Signal strength
[G: Good, B: Bad]
Quality Level
[0 to 100]
n Changing the information display
n Memorising a station
+
+
+
+
+
+
Transfer speed Channel type
[ST: Stereo, MO: Mono]
+