Pioneer X-HM30DAB-K - Manual (Page 45)

X-HM30V_DAB_En.fm
En-45
2011August 30
8
7
6
5
4
3
2
1
Troubleshooting chart (continued)
Caution:
This operation will erase all data stored in memory
including clock, timer settings, tuner preset.
Remove the iPod, USB memory device and disc from the
unit. Then, set the unit to the power stand-by mode.
Carrying the unit with iPod or USB memory device left
docked or discs left inside might damage the unit.
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
l Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
l Keep your discs away from direct sunlight, heat, and
excessive moisture.
l Always hold the CDs by the edges. Fingerprints, dirt, or
water on the CDs can cause noise or mistracking. If a
CD is dirty or does not play properly, clean it with a soft,
dry cloth, wiping straight out from the centre, along the
radius.
Maintenance
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
l Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
l Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specifications
As part of our policy of continuous improvement,
PIONEER reserves the right to make design and
specification changes for product improvement without
prior notice. The performance specification figures
indicated are nominal values of production units. There
may be some deviations from these values in individual
units.
n Factory reset, clearing all memory
For DISC/USB Video function:
Please refer "Changing the Setup Menu" on page 13.
Select "PREFERENCE", "DEFAULT" and then "RESET".
For others function:
1 Press the STANDBY/ON button to turn the power on.
2 Press the LINE button on the remote control or INPUT
button repeatedly on the main unit to select LINE IN
function.
3 In LINE IN function, press the button on the
main unit press and hold the button until "RESET"
appears.
n Before transporting the unit
n Care of compact discs
n Cleaning the cabinet
NO YES
Correct
n General
Power source AC 220 V to 240 V, 50 Hz/60 Hz
Power
consumption
Power on: 50 W
Power stand-by: 0.4 W
Dimensions Width: 215 mm
Height: 99 mm
Depth: 300 mm
Weight 3.9 kg
n Amplifier
Output power RMS: 30 W + 30 W (1 kHz, 10 %
T.H.D., 4 ohms)
Output terminals Speakers: 4 ohms
20 Hz to 20 kHz
Coaxial digital output
Headphones: 16 ohms
(recommended: 32 ohms)
Input terminals Line in (Analog input):
500 mV/47 k ohms
n DVD player
Signal
system
PAL/NTSC color
Supported
disc types
DVD (with the same region number on the
back of the unit), SVCD, VCD, audio CD,
CD-R, CD-RW, JPEG, DivX (version 3.0)
Video
signal
Horizontal resolution: 500 lines
S/N ratio: 70 dB
Audio
signal
Frequency
characteristic
Linear PCM DVD: 20 Hz to
20 kHz (sampling rate: 48
kHz)
20 Hz to 20 kHz (sampling
rate: 96 kHz)
CD: 20 Hz to 20 kHz
S/N radio CD: 94 dB (1 kHz)
Dynamic
range
Linear PCM DVD: 95 dB
CD: 94 dB
Total
harmonic
distortion
ratio
0.01 % maximum