Pioneer AVG-VDP1 - Manual (Page 28)

Introduction of setup
adjustments
1
Setup adjustments lets you perform setup of
different settings for this unit.
1 Function display
Shows the setup function names.
% Touch Menu and then touch SETUP.
The function names are displayed.
# When Menu is not displayed, you can display
it by touching the screen.
# To return to the previous display, touch Back.
# To return to the normal display of each mode,
touch ESC.
Setting the volume level
You can set the volume of the beep sound.
1 Touch Menu and then touch SETUP.
2 Touch Volume.
3 Touch + or  to set the desired volume
level.
Calibrating the RPMs
Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer and torque meter of this unit
cannot work if you do not perform the RPM
calibration. And also, the other meters can-
not work properly.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Touch Menu and then touch SETUP.
3 Touch Tachometer Setting.
When a message is displayed, touch OK.
4 Keep RPMs of the engine at 4000 rpm
and touch 4000 rpm.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4000 rpm for a few
seconds.
# Some vehicles have a rev limiter that kicks in
early (e.g., 3000 rpm) while parking. In this case,
perform RPM measurement at 2000 rpm.
Setting your vehicle weight
Vehicle weight must be set properly in order to
calculate correct horsepower of your vehicle.
1 Touch Menu and then touch SETUP.
2 Touch Vehicle Weight Setting.
3 Touch a or b to set your vehicle
weight.
# You can switch a unit of weight between kg
(kg) and lb (lb) by touching kg or lb.
# Weight value is reset when you change to an-
other unit of weight.
Setup adjustments
En
28
Section
08