Pioneer DBR-TF100 - Manual (Page 7)

Getting ready 01
7
En
gli
sh
9
RED, GREEEN, YELLOW, BLUE but-
tons
Used for Text Mode and on-screen
operations.
0
Refer to Setting TV codes on the right.
This remote can directly control the TVs
of major manufacturers. At the time of
shipment the remote is preset to operate
Pioneer TVs.
-
SUBTITLE button (P.30)
Press to display subtitles.
= WIDE button (P.32)
Press to switch between wide-screen view-
ing modes.
~
EXIT button
Press to remove on-screen displays.
!
MENU button
Press to display the menu screen.
@
RETURN button (P.15)
• Press to select the last displayed chan-
nel.
• Press to return to the previous menu
screen.
Putting batteries in the
remote
To add or change the batteries, slide open the
battery compartment cover on the back of the
remote control by pushing it down and sliding
it open.
Add two new
AA batteries.
Setting TV codes
The remote can control the following five
functions by entering a TV brand code from
the attached list.
• TV on/standby or off
• TV volume up/down
• TV channel up/down
• Sound mute on/off
• Switch between TV/AV input
1 Press and hold the TV STANDBY but-
ton (A on the illustration), enter the 4-digit
TV brand code. (Refer to Chapter 9, TV brand
code, page 37.)
2 Pressing the TV STANDBY button (A
on the illustration) again, should switch the
TV on/off.
3 If the TV fails to operate, repeat the op-
eration in Step 1 above, or enter a different
code for the same brand of TV.
• It might not be possible to use this
remote with some TV brands or models.
• If necessary, the remote can be reset to
the factory default setting. While press-
ing the
TV STANDBY button, enter
the code 9999.