Pioneer CNDV-50MT - Manual (Page 109)

107
A
ppe
n
d
ix
NA
V
I/A
V
Appendix
Installing the Program
The program is installed to the Navigation
System using the application disc.
This is not necessary if your dealer already
performed the installation.
When installing the program, you carry out the
following operations. When all the setup
procedures are completed, you can use the
Navigation System.
1
Park your vehicle in a safe place.
Leave the engine on, and make sure that the
handbrake is applied.
2
Insert the Pioneer DVD Map disc to the
disc loading slot of the Navigation
System.
When the upgraded program has been found,
installation of the program starts immediately.
• Once the installation of the program starts,
do not stop the engine of your vehicle nor
switch off the Navigation System until the
installation is completed and the following
Audio screen appears.
3
Press the NAVI/AV button to change the
navigation screen.
4
Touch “Yes/Oui/Ja”.
When you start the navigation unit for the first
time, you will see a confirmation message
asking if you wish to select another language.
English is the default language of the
Navigation System. If desired, you can select
another language as shown.
❒
To keep English, touch “No/Non/Nein”.
After this, proceed to Step 7.
❒ When you want to select another
language, touch “Yes/Oui/Ja”, and
proceed to the next step.
5
Select the language from the list.
Touch the language you want to use.
❒ The language selected here is reflected for
the Navigation functions (e.g., Destination
search, etc.) only.
➲ To Change the language ➞ Page 56
Installation of the program, in the language
you chose, begins.
1
Insert the disc while the vehicle is
parked.
2
Select the language used for the
Navigation System.
3
Setting the clock.
MAN-CNDV-50MT-EN.book Page 107 Wednesday, May 4, 2005 1:49 PM