Pioneer CNDV-50MT - Manual (Page 97)

95
Ch
ap
te
r
8
Cu
st
o
m
isin
g t
h
e A
u
dio
S
o
u
rc
e S
et
tin
g
AV
Switching Auto PI seek
The unit can automatically search for a different
station with the same programming, even during
preset recall.
1
Touch “AUTO PI” in the INITIAL menu.
Touching “AUTO PI” switches between “ON”
and “OFF”.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
navigation unit. Activate the auxiliary setting
when using auxiliary equipment connected to
navigation unit.
1
Touch “AUX” in the INITIAL menu.
Touching “AUX” switches between “ON” and
“OFF”.
Selecting the illumination
colour
This unit is equipped with two illumination
colours, green and red. You can select the
desired illumination colour.
1
Touch “ILLUMI” in the INITIAL menu.
Touching “ILLUMI” switches between
“GREEN” (green) and “RED” (red).
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads output
and RCA rear output) can be used for full-range
speaker (REAR SP FULL) or subwoofer (REAR
SP SUB. W) connection. If you switch the rear
output setting to the REAR SP SUB. W, you can
connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, navigation unit is set for rear full-range
speaker connection (REAR SP FULL). When
rear output is connected to full range speakers
(when REAR SP FULL is selected), you can
connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass filter,
phase) built-in PREOUT SUB. W or the auxiliary
PREOUT FULL.
1
Touch “REAR SP” in the INITIAL menu.
2
Touch “REAR SP” to switch the rear
output setting.
When no subwoofer is connected to the rear
output, select FULL.
When a subwoofer is connected to the rear
output, select SUB. W.
❒
When the rear output setting is SUB. W,
you cannot change the subwoofer
controller.
3
Touch “PREOUT” to switch the
subwoofer output or non fading output.
❒
Even if you change this setting, there is no
output unless you turn “NON FADING” or
“SUB WOOFER” in the AUDIO menu
“ON”.
➲ Using non fading output ➞ Page 91
➲ Using subwoofer output ➞ Page 91
❒ If you change the subwoofer controller
(REAR SP), the subwoofer output (SUB
WOOFER) and non fading output (NON
FADING) in the AUDIO menu return to
the factory settings.
❒ Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Switching the sound muting/
attenuation
Sound from this system is muted, attenuated or
mixed automatically in the following cases:
• When a call is made or received using a
cellular telephone connected to navigation
unit.
• When the voice guidance is output.
1
Touch “TEL/GUIDE” in the INITIAL
menu.
Each touch of the “TEL/GUIDE” changes the
settings as follows:
• MUTE – Muting
• ATT – Attenuation
• NORMAL – Volume does not change
❒
The sound is turned off, no audio
adjustment is possible.
❒ When a phone connection is made, MUTE
or ATT is indicated.
In
it
ia
l S
et
tin
gs
MAN-CNDV-50MT-EN.book Page 95 Wednesday, May 4, 2005 1:49 PM