Pioneer DEH-P9600MP - Manual (Page 60)

3 Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g., AUX ON).
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Press FUNCTION to select Dimmer.
Press FUNCTION repeatedly until Dimmer ap-
pears in the display.
2 Press a or b to turn Dimmer on or off.
Pressing a or b will turn Dimmer on or off
and that status will be displayed (e.g.,
Dimmer ON).
Adjusting the brightness
Display brightness adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Press FUNCTION to select Brightness.
Press FUNCTION repeatedly until Brightness
appears in the display.
2 Press c or d to adjust the brightness
level.
Each press of c or d increases or decreases
the brightness level. 00  31 is displayed as
the level is increased or decreased.
Correcting distorted sound
When listening to a CDor other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 Press FUNCTION to select Digital ATT.
Press FUNCTION repeatedly until Digital ATT
appears in the display.
2 Press c or d to switch Digital ATT high
or low.
Pressing c or d will switch between High
(high) and Low (low) and that status will be
displayed.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
Initial Settings
En
60
Section
10