Pioneer AVIC-X3-II - Manual (Page 10)

Connecting the power cord (1)
ISO connector
*1
*2
*4
*3
*5
Depending on the kind of vehicle, the function
of *3 and *5 may be different. In this case, be
sure to connect *2 to *5 and *4 to *3.
Connect leads of the
same colour to each
other.
Cap (*1)
When not using this terminal,
do not remove the cap.
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
Yellow (*2)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*4)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Orange/White
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Note Notes
Fuse resistor
Fuse resistor
• When a subwoofer (*8) is connected to this
navigation system instead of a rear speaker,
change the rear output setting in the Initial Setting.
(Refer to the operation manual.) The subwoofer
output of this navigation system is monaural.
• When using a subwoofer of 70 W (2 Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Fuse holder
Fuse (10 A)
Note
In some vehicles, the ISO connector
may be divided into two. In this
case, be sure to connect to both
connectors.
Speaker leads
White: Front
left
White/Black: Front left
Grey: Front right
Grey/Black: Front right
Green: Rear left
or Subwoofer (*8)
Green/Black: Rear left or Subwoofer (*8)
Violet: Rear right or Subwoofer (*8)
Violet/Black: Rear right or Subwoofer (*8)
Connecting the System
Engb
10
Section
03