Pioneer AVIC-X3-II - Manual (Page 29)

After Installing this
Navigation System
1 Reconnecting the battery.
First, double-check that all connections are
correct and that this product is installed cor-
rectly. Reassemble all vehicle components
that you previously removed. Then reconnect
the negative (
–) cable to the negative (–) term-
inal of the battery.
2 Start the engine.
3 Press RESET button.
Press RESET button on the display unit using
a pointed object such as the tip of a pen.
4 Enter the following settings:
1 Install the programme in the navigation sys-
tem.
2 Set the time and language.
3 Drive until the initialised sensors start oper-
ating normally.
Set the navigation system as explained in the
operation manual.
Note
After installing this navigation system, be sure to
check at a safe place that the vehicle is perform-
ing normally.
After Installation
Engb
29
English
Section
05