Pioneer AVIC-X3-II - Manual (Page 25)

2 Install the unit into the dashboard.
After inserting the holder into the dashboard,
select the appropriate tabs according to the
thickness of the dashboard material and bend
them. (Install as firmly as possible using the
top and bottom tabs. To secure, bend the tabs
90 degrees.)
182
53
Rubber bush
Dashboard
Side bracket
Screw (2 mm 3 mm)
Holder
Double-ended
screw
! When using the side brackets (large), reat-
tach the frame.
DIN Rear-mount
Installation using the screw holes on
the side of the unit
% Fastening the unit to the factory radio-
mounting bracket.
Select a position where the screw holes of the
bracket and the screw holes of this product
become aligned (are fitted), and tighten the
screws at 2 places on each side. Use any of
screws (4 mm × 3 mm), binding screws (5 mm
× 6 mm) or flush surface screws (5 mm ×
6 mm), depending on the shape of the screw
holes in the bracket.
*1 Use screws (4 mm × 3 mm) only.
*1
*1
! When installing in a shallow space, use the
following screw holes. In this case, stick
conceal tape on parts that protrude from
the dashboard.
Conceal tape
*1
*1
Dashboard or
Console
Factory radio
mounting bracket
Binding screw
(5 mm 6 mm)
Fixing the front panel
If you do not operate the removing and attach-
ing the front panel function, use the supplied
fixing screws to fix the front panel to the dis-
play unit.
% Fix the front panel to the display unit
using the fixing screws after removing the
frame.
Fixing screws
Installation
Engb
25
English
Section
04