Pioneer VSX-D510 - Manual (Page 16)

16
En
05
Displays & Controls
Display
1 SIGNAL SELECT indicators
Lights to indicate the type of input signal assigned for
the current component :
2 DIGITAL : Lights when a DOLBY DIGITAL
signal is played.
DTS : Lights when a source with DTS audio signals
is played.
ANALOG : Lights when an analog signal is selected.
DIGITAL : Lights when a digital audio signal is
selected.
2 DTS indicator
Lights when DTS mode is being used.
3 2 DIGITAL indicator
When the 2 (DOLBY)/DTS mode of the receiver is
on, this lights to indicate playback of a Dolby Digital
signal. However, 2 PRO LOGIC lights during two
channel playback of Dolby Digital.
4 OVERLOAD indicator
This lights when an analog signal is too high (the
SIGNAL SELECT would have to be on ANALOG). It
indicates the sound is distorting and the input signal
should be reduced.
5 ATT indicator
Lights when ATT is used to attenuate (reduce) the
level of the input signal (can only be used in ANA-
LOG mode).
6 DIRECT indicator
Lights when source DIRECT is in use. This function
bypasses all tone, balance, DSP and Dolby Surround
effects.
7 SPEAKER indicator
Shows if the speaker system is on or not. SP
3A
means speakers are switched on. SP
3 means
speakers are switched off.
8 MONITOR indicator
Lights when MONITOR is selected. Used to hear a
recording as it's being made (see page 30).
9 RF ATT indicator
Lights when the RF ATT is on (see page 24).
0 EON indicator
The box around EON indicator lights to inform you
that the currently tuned station carries the EON data
service. When the EON mode is set, the
EON
indicator ligh†s, but during actual reception of an
EON broadcast the
EON indicator will flash. An
empty box in the EON indicator spot means it is
possible to pick up an EON broadcast but the
receiver has not been set to do so (this will only
appear when RDS is switched on).
- RDS indicator
Lights when an RDS broadcast is received.
= CHARACTER display
Shows the radio frequency or function (DVD/LD, CD,
etc.) receiver is using.
~ 2 PRO LOGIC indicator
When the 2 (DOLBY)/DTS mode of the receiver is
on, this lights to indicate playback of a two channel
source.
! DSP indicator
Lights when any Advanced Theater or DSP mode is
selected.
@ MIDNIGHT indicator
Lights when MIDNIGHT listening mode is in use.
# LOUDNESS indicator
Lights when the LOUDNESS is on. Use to boost the
bass and treble at low volume.
$ TUNER indicators
MONO :
Lights when the mono mode is set using the MPX
button.
TUNED :
Lights when a broadcast is being received.
STEREO :
Lights when a stereo FM broadcast is being received
in auto stereo mode.
% MASTER VOLUME LEVEL
Shows the overall volume level. Volume level is
maintained even when the power is off.
---dB
indicates the minimum level, and 0dB indicates the
maximum level.
• Depending on the level settings you make for
individual channels, the MAX level can range
between –10dB and 0dB.
dB
SIGNAL SELECT
MIDNIGHT
LOUDNESS
DIRECT MONITOR
TUNED
MONO ANALOG DIGITAL
SP A DIGITAL DTS
DIGITAL
PRO LOGIC
ATT
DSP
RF ATT EON
STEREO RDS
1 2 3 4 5 6 7 8 9 0 -
= % ~ ! @ # $