Pioneer VSX-D510 - Manual (Page 21)

21
En
Switching ANALOG/DIGITAL
Signal Input
When you select a function (for example CD) that is
only hooked up by a digital connection, then the
ANALOG/DIGITAL signal input switch will
automatically choose digital. If you have that function
hooked up by both digital and analog connections this
switch lets you choose which to listen to.
1 Press RECEIVER .
This switches the remote to the surround setup
mode.
2 Press SIGNAL SELECT to select the input
signal corresponding to the source
component.
Each press switches between ANALOG and DIGITAL
signal selection.
3 While SIGNAL SELECT is set to DIGITAL,
2 DIGITAL lights when a Dolby Digital
signal is input, DTS lights when a DTS signal
is input.
MEMO:
• SIGNAL SELECT is fixed in the “ANALOG” position
for components not assigned to one of the two digital
input jacks.
• This receiver can only play back Dolby Digital, PCM
(32kHz, 44kHz, and 48kHz), DTS, digital signal
formats. With digital signal formats other than these,
set SIGNAL SELECT to “ANALOG”.
• When a LD or CD player compatible with DTS is
played back with SIGNAL SELECT set in “ANALOG”,
digital noise may be output by playing back the DTS
directly (no decoding). To prevent noise, you need to
make digital connections (Refer to page 6) and set
SIGNAL SELECT to “DIGITAL”.
• Some DVD players don’t output DTS signals. For
more details, refer to the instruction manual supplied
with your DVD player.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
ATT
CH
2 DSP MODE MIDNIGHT 5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL EFFECT
FUNC
SIGNAL
SELECT
TEST
TONE
RECEIVER TUNER TV CONT
Î
1 2 3 4
5 6 7 8
9 0 10 DISC
1
2
Sound Modes
Playing Sources with Dolby
Digital or DTS Sound
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
Be sure that the standby indicator turns off on the
front panel.
3 Press a MULTI CONTROL button to select
the source you want to playback.
If the DIRECT FUNCTION is OFF you have to use
the
FUNCTION button to select the source (see p.
32).
4 Press RECEIVER .
Then set the remote to select the sound mode.
5 Press SIGNAL SELECT to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input”
on this page.)
6 Press 2 to switch the Dolby/DTS mode on.
7 Start playback of the component you
selected in step 1.
8 Press MASTER VOLUME (+/–) to adjust the
volume level.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS
ATT
VOL
MENU
TOP
MENU
VOL
CH
2 DSP MODE MIDNIGHT 5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL EFFECT
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
TV CONTROL
FUNC
SIGNAL
SELECT
TEST
TONE
RECEIVER TUNER TV CONT
1 2 3 4
5 6 7 8
9 0
SOURCE CLASS MPX BAND
10 DISC
CHANNEL
DISPLAY RF ATT
4
6
8
2
2
3
5
3