Barnett Engineering Pro Talk ARU CV2 - Manual (Page 31)

Configuration using the PC 3-17
B1272M001 BARNETT ENGINEERING LTD. ProTalk Cv2
Signal
If a DTMF tag is programmed for a point and the Signal command is set, then only the
DTMF tag for this point will be sent and the voice message will not be spoken.
Signal must be preceded by a Dial command; it cannot be the first entry in the list. It can
be used once in a list.
Delete
Delete removes the selected command from the list. Commands that followed the deleted
one are moved to fill in the empty space. If the first command is selected, then Delete will
remove all commands for this line.
3.5.5 General
Settings that affect the overall operation of the Cv2 are entered in the General section.
Site Name
The Site Name is a 16 character text field that allows you to enter a description of the site
where the Cv2 is to be located. Other than viewing in the General dialog box, this name
has no other use. Normally it is set to match the voice message that is programmed as the
Site Identifier.
Default Site Name: an empty text string.
Security Level
The Security level setting determines the actions that the Cv2 will perform when it receives
an incoming call.
Level 1 The Cv2 announces the Site ID, any groups that are in the alarm state
and prompts the caller to “Enter Command Code”.
Level 2 When the incoming call is answered by the Cv2, only the Site ID is
announced; for further access to the Cv2 the caller must enter the
Access Code.
Level 3 An incoming call results in the Cv2 coming off-hook with no
announcement; the Access Code must be entered within ten seconds or
the Cv2 will hang up.
Default Security Level: Level 1
Access Code
If you plan to use the remote programming features where changes are made
by calling the unit from a remote phone, an access code must be programmed.
For remote programming, all security levels require the Access code. For local
programming, the Access code must be entered if the unit has this code. Local