Barnett Engineering Pro Talk ARU CV2 - Manual (Page 33)

Configuration using the PC 3-19
B1272M001 BARNETT ENGINEERING LTD. ProTalk Cv2
operational.
Data is transferred in four-kilobyte packets at 9600 baud. The configuration database will
take two packets to transfer; the number of packets in a voice data transfer will vary
depending on how many points are used and how long the messages are.
Configuration Data
To transfer configuration data, use the two buttons in the Configuration box. Press the
Write To Cv2 button to transmit the configuration database from the PC into the Cv2 or
press the Read From Cv2 button to transfer the configuration from the Cv2 to the PC .
Voice Messages
To transfer voice data, use the buttons in the Voice box. Press the Write to Cv2 button to
move voice messages from a file in the PC to the Cv2. The recorded messages in the Cv2
can be read and stored to a file by pressing the Read From Cv2 button. At the end of each
voice programming session, it is advisable to read the voice information in the Cv2 and
store it to file.
Vocabulary
If the stored vocabulary section in the Cv2 memory is corrupt it will be necessary to
transfer the vocabulary from the PC to the Cv2. The most common symptom associated
with a corrupt vocabulary is the absence of the female voice prompts during operation and
programming. If problems are experienced with any of the voice operations the vocabulary
should be replaced. This is done by pressing the Write Vocabulary button to transmit the
vocabulary data to the Cv2.
Writing the vocabulary to the Cv2 will delete all of the user stored messages. If these
messages were previously saved to a file they can be transferred after the vocabulary is
written into the Cv2, otherwise they will have to be recorded again.