Barnett Engineering Pro Talk ARU CV2 - Manual (Page 34)

Voice Storage and Configuration with the Telset 4-1
B1272M001 BARNETT ENGINEERING LTD. ProTalk Cv2
4 Voice Storage and Configuration with the Telset
4.1 Setup
After the configuration database has been transferred to the Cv2, it is ready to accept the
voice messages that will be used in the alarm reporting process and it is possible to change
some of the configuration data that was transferred from the PC. First ensure a database
has been downloaded from the PC to the Cv2. The Cv2 must contain a valid database in
order to determine which points have associated voice messages.
The usual method for voice programming is with a phone set plugged directly into the unit;
however it is also possible to program voice messages remotely by calling the Cv2 over the
phone network.
If you are programming a stand-alone Cv2, a DTMF (TouchTone) telephone set is required
to enter the voice messages. A rotary dial pulse telephone set will not work here. Connect
the phone set to port J1. If you have a package model, the phone set will already be in the
enclosure.
In place of the Enter key or carriage return which you would use to enter data from a
keyboard, the Cv2 interprets the characters
UU as the Enter command. The programming
sequence is controlled by pressing a single digit followed by the
UU digits. Ensure that no
more than one second separates the two
U digits.
4.2 Access
To begin a local programming session, lift the telephone handset to your ear. To perform
remote programming call the site from a remote telephone set.
The Cv2 has stored voice prompts to guide you through the programming mode. The first
message you will hear is “Enter Command Code.” At this time you can interrogate,
acknowledge or control the unit. If the Access Code is entered, the prompt changes to
“Enter Program Code” and all LEDs illuminate. The same action occurs if you are calling
in remotely.
With the security level set to ‘1' with local programming, the Cv2 will advance to the
program mode automatically after 5 seconds if an access code is not entered. An access
code is needed for remote programming with all security level settings and locally for
levels 2 and 3.
4.3 Commands
After the security requirements have been met, you can begin programming voices or
changing the configuration by entering a command code. Each code produces a response
from the Cv2 as described below:
0
UU - Edit Directories
Cv2: “Enter Directory Code”
After the Cv2 responds with this prompt it waits for you to enter a selection from the