Bajaj Electricals DB30 - Manual (Page 18)

15
CHANGING THE OIL
1. Remove the “Screw Plug” located at the bottom of the engine and let the
oil drain into an approved collection container. DO NOT PERFORM THIS
PROCEDURE WHILE THE ENGINE IS HOT. SERIOUS BURNS COULD RESULT
FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures, contact
your local oil recycling center.
3. Clean and replace the “Screw Plug” tightly.
4. Refill the engine with the proper amount of oil and recheck the amount of oil
in the engine by using the oil gauge plug.
CHECK-UP OF SPARK PLUG
1. Remove the cap of spark plug and screw off the
spark plug using the plug wrench.
2. Clean the spark plug all around or replace it if it is
corroded or there is too much deposit on it.
3. Regulate the gap of the spark plug to
.7mm - .79mm (.028”-.031”).
4. The spark plug of the designated type should be
used. The applicable type of spark plug:
.7mm - .79mm
(.028” - .031”)
Screw plug for oil draining
INSPECTION AND MAINTENANCE
Autolite-258, AC-CS49, Champion-CJ14,
NGK-BM4A, Denso-W14M-US