Bajaj Electricals DB30 - Manual (Page 20)

17
ADJUSTING THE THROTTLE CABLE
Make sure the throttle cable is adjusted properly. To adjust throttle cable, rotate
adjustment nut located at the hand throttle.
Check if the throttle twist grip has the required free operating movement.
The required free operating movement: 2-6mm (.078 -.24in.) . If the grip cannot be
moved freely, turn the adjusting nut to ensure proper operating movement.
After adjustment, start the engine and check for the operating movement again.
Repeat the adjustment if necessary until the desired operating movement is
obtained.
ADJUSTING THE CARBURETOR
Adjusting procedures of idling speed:
1. Support the vehicle by a stand.
2. Adjust the idle speed by the throttle stop screw to 1400 +200 RPM
-150.
CAUTION
Do not try to correct a malfunctioning carburetor by adjusting the idling
speed. If the carburetor is not functioning properly, it should be repaired
by a service center.
Adjust idling speed only when the engine is warmed up or 10 minutes after
operation.
Throttle cable adjust nut
INSPECTION AND MAINTENANCE