Toshiba Tecra M4 User Manual
Page 188
TECRA M4
9-10
Troubleshooting
Some CD/DVDs run
correctly, but others do
not
The software or hardware configuration may be
causing a problem. Make sure the hardware
configuration matches your software’s needs.
Check the CD/DVD’s documentation.
Check the type of CD/DVD you are using. The
drive supports:
DVD-ROM:
DVD-ROM, DVD-Video
CD-ROM:
CD-DA, CD-Text, Photo CD
TM
(single/multi-session),
CD-ROM Mode 1, Mode 2,
CD-ROM XA Mode 2 (Form1,
Form2), Enhanced CD
(CD-EXTRA), Addressing
Method 2
Recordable CD: CD-R, CD-RW
Check the region code on the DVD. It must
match that on the DVD-ROM&CD-R/RW drive.
Region codes are listed in the
section in Chapter 2, The Grand Tour.
Cannot write correctly If you have trouble writing, make sure you are
observing the following precautions:
■
Use only media recommended by TOSHIBA.
■
Do not use the mouse or keyboard during
writing.
■
Use only the software supplied with the
computer for recording.
■
Do not run or start other software during
writing.
■
Do not jar the computer during writing.
■
Do not connect/disconnect external devices
or install/remove internal cards during writing.
If problems persist, contact your dealer.
Problem
Procedure