Sharp R-1900M User Manual
Page 15
14
NOTES:
1. Only Dual Digit Input method can be used when inputting
memory numbers in Counter Check/Clear.
2. To clear total manual cooking usage, press the MANUAL/
REPEAT pad in Step 2 instead of the number pad.
3. To clear total Express Defrost usage, press the EXPRESS
DEFROST pad in Step 2 instead of the number pad.
4. To clear total usage, skip Step 2.
8. Air Intake Filter Counter
Use Custom Setting Function for Air Intake Filter Counter to
check total usage hours since the Air Intake Filter was last
reset to “0”.
CU81 : The total used air intake fi lter time appears.
CU82 : The limit time for using a fi lter can be changed.
1 Press the CUSTOM
SETTING pad twice within
2 seconds, then enter 7.
Total usage will be
displayed.
Procedure
x 2
2 Enter memory
number 1 to check
the total memory
usage of memory 1.
3 Press the START pad.
0
7
1
4
Press the STOP/CLEAR pad to
exit from the Custom Setting
Function.
To Reset the Counter to “0”
Each counter can be manually reset to “0” by pressing the
START pad after the count is displayed.
* Suppose you want to reset the count for memory number
1 in any Memory Input Method
Use Custom Setting Function for Air Intake Filter Counter to
change the Air Intake Filter cycle from 001-999. The factory
setting is 100 hours. When 100 hours is exceeded, the
FILTER indicator in the display will start to fl ash on and off
as a reminder to clean the air fi lter, even if in the middle of
cooking. Furthermore “FILt“ fl ashes on and off in stead of
displaying “ . “ during standby and at the same time FILTER
indicator fl ashes on and off. Clean Air Intake Filter (See page
22 - 23), when the FILTER indicator appears in the display,
and then clear the total usage to reset it to “0” .
* Suppose you want to know the total usage hours which
has been 99 hours since the last reset.
To Reset the Air Intake Filter Counter
Reset the Air Intake Filter Counter after cleaning the air
intake fi lter.
* Suppose you want to reset the air fi lter counter which has
been 101 hours since the last reset and the Air Intake Filter
cycle is preset to 100.
CHECK
Procedure
Display
1 Press the CUSTOM SETTING
pad twice within 2 seconds
and enter 8,1.
2 Press the START pad to
reset the counter to “0”.
CHECK
3 Press the STOP/CLEAR pad to exit
from the Custom Setting Function.
FILTER
After about 1 sec.
1 Press the CUSTOM SETTING
pad twice within 2 seconds
and enter 8, 1.
Procedure
Display
x 2
8
1
2 Press the STOP/CLEAR pad to exit
from the Custom Setting Function.
After about 1 sec.
NO. CHECK
NO. CHECK
CHECK
CHECK
CHECK
After about 1 sec.
x 2
8 1
After about 1 sec.
R-1900M [EN].indd Sec1:14
R-1900M [EN].indd Sec1:14
7/4/09 9:50:02 AM
7/4/09 9:50:02 AM