Sharp R-1900M - Manual (Page 40)

39
O REPLACE THE MAINS PLUG
T
The wires in the mains cable are colour coded as shown
opposite:
As the colours of the cores in the mains lead of your oven
may not correspond with the coloured marking identifying
the terminals in your plug, connect the wires as shown:
Make sure the terminal screws are tight and the cable is held
securely by the cable grip where it enters the plug. Like most
appliances in your home, your oven must be connected to a
single phase 230-240 Volt, 50Hz alternating current supply.
If you do not make the proper electrical connections you
might damage the oven or injure yourself. Neither SHARP
nor the supplier will be liable if this happens.
THIS APPLIANCE MUST BE EARTHED.
IF YOU HAVE ANY DOUBTS ABOUT YOUR ELECTRICAL
SUPPLY ASK A QUALIFIED ELECTRICIAN.
green and yellow stripes = EARTH
blue = NEUTRAL
brown = LIVE
• The green and yellow wire to the plug terminal marked E
or or coloured green or coloured green and yellow.
• The blue wire to the plug terminal maked N or coloured
black or coloured blue.
• The brown wire to the plug terminal marked L or coloured
red or coloured brown.
WARNING:
ALLING FOR SERVICE
C
• If you are unable to resolve a problem using the checks
covered on the last few pages, do not attempt to service
this microwave oven yourself.
• Contact the dealer or supplier from whom the oven was
purchased in order to obtain service. Where this is not
possible, please contact the SHARP Customer Information
Centre, telephone:
08705 274277 (offi ce hours).
• For general information & assistance with oven queries,
please contact our
Customer Information Centre:
U.K.: 08705 274277 (offi ce hours)
Ireland: 01 676 0648 (offi ce hours)
Website: http://www.sharp.co.uk/support
• Replacement accessories may be obtained from our main
parts distributor Willow Vale Electronics Ltd.
Telephone: 0121 766 5414
R-1900M [EN].indd Sec1:39 R-1900M [EN].indd Sec1:39 7/4/09 9:50:10 AM 7/4/09 9:50:10 AM