Neff C47C22N3GB - Manual (Page 13)

13
Preset operation
The appliance switches on automatically, then switches off
automatically at the time preselected for the end of operation.
Bear in mind that food that spoils easily must not stay in the
cooking compartment for too long.
Preselection mode is not possible with some of the automatic
programmes.
When
é Steam cooking, the cooking time does not start until
the heating up time has elapsed. The end of operation which
was set is therefore delayed by the length of time required for
heating-up.
1. Set the operating mode and temperature.
2. Press the clock function button repeatedly until the
KJ and
x symbols light up.
3. Set the cooking time with the rotary selector
(e.g. ‚ : „‹ hours).
4. Press the clock function button repeatedly until the KJ
and y symbols light up.
5. Set the end of operation using the rotary selector
(e.g. ‚ƒ : „‹ ).
6. Press the Start button.
The appliance waits until the appropriate time to switch on (in
the example at ‚‚ : ‹‹ ).
The appliance switches off automatically at the time set for the
end of operation ( ‚ƒ : „‹ ). A signal sounds and the y symbol
flashes.
1. Turn the operating mode selector back to the
Û position.
2. Press the clock function button to end the preselection mode.
Setting the clock
You can only change the clock when no other clock function is
active.
1. Press the
KJ clock function button repeatedly until
the KJ and 3 symbols light up.
2. Set the clock using the rotary selector.
The setting is applied automatically.
Checking, correcting or deleting settings
1. To check your settings, press the KJ clock function button
repeatedly until the corresponding symbol lights up.
2. If necessary, you can correct your setting using the rotary
selector.
3. If you wish to cancel your setting, turn the rotary selector anti-
clockwise to the original value.
Automatic programmes
You can prepare food really easily with 40 different
programmes.
In this section, you will find out
■
how to set one of the automatic programmes
■
hints and tips on the programmes
■
which programmes you can set
Setting a programme
Select the appropriate programme from the programme table.
Follow the instructions for the programmes.
1. Press on the operating mode selector to turn on the
appliance.
2. Press the n button.
The first programme ˜ : ‹‚ appears on the temperature
display.
3. Select the programme with the temperature selector.
4. Press the n button again.
A default weight appears on the temperature display.
For some programmes, you do not have to enter a weight. In
such cases, no default weight is displayed.
5. Turn the temperature selector to set the weight.
6. Press the Start button.
No heating indicator appears.
Checking the cooking time
Press the clock function button KJ repeatedly until the KJ
and x symbols light up.
Programme with preselected mode y
For some programmes, you can set a y Preselection mode.
The programme will be started later and finish at the desired
time (see Section: Electronic clock).
Cancelling the programme
Press and hold the Stop button.
End of the programme
An audible signal sounds. Cooking has finished. To turn off the
appliance, press in the operating mode selector so that it clicks
into place.
:
Risk of scalding!
Hot steam may escape when the appliance door is opened.
Open the appliance door carefully during or after cooking.
When opening the door, do not lean over it. Ensure that,
depending on the temperature, steam is not visible.
6WDUW
3NJ
6WDUW
3NJ