Lift the door panel and remove it (figure b), Removing the intermediate panel, Press the left and right-hand holders outwards – Neff C47C22N3GB User Manual

Page 21: Cleaning, Caution, Fitting the intermediate panel, Fitting the door panel, Slide in the door panel all the way, Put the cover back in place and screw it in, Refit the appliance door

Advertising
background image

21

1. Unhook the appliance door and lay it on a soft, clean surface

with the front side facing downwards (see section: Removing

and installing the appliance door).

2. Unscrew the cover at the top left and right of the appliance

door and detach it (figure A).

3. Lift the door panel and remove it (figure B).

Removing the intermediate panel
Before removing, make a note of the position in which the

intermediate panel is fitted, so that you do not refit it the wrong

way round later.

1. Press the left and right-hand holders outwards.
2. Lift the intermediate panel slightly and take it out.

Cleaning
Clean the door panels with glass cleaner and a soft cloth.

Caution!
Do not use any sharp or abrasive medium or a glass scraper.

The glass could be damaged.

Fitting the intermediate panel

1. Insert the intermediate panel on the left and right into the

supports.

2. Push the intermediate panel downwards in the retainers.

Fitting the door panel

1. Slide in the door panel all the way.
2. Put the cover back in place and screw it in.
3. Refit the appliance door.

Cleaning the rails

The rails can be removed for cleaning.

:

Risk of burning due to hot components in the cooking

compartment!
Wait until the cooking compartment has cooled down.
Detaching the rails
Note:
Swing the front of the rail as far as possible (until you feel

resistance), because otherwise the appliance side panel may

become bent.
1. Carefully press the front of the rail upwards until it becomes

detached, and release it from the holder at the side (fig. A).

2. Detach the rail from the holder and remove it (fig. B).

3. Clean the rails with washing-up liquid and a sponge/brush

or

Clean the rails in the dishwasher.

Attaching the rail
1.
Position the rail so that the indentations are facing upwards.
2. Hook the rail in at the back and push it towards the rear until

it engages (fig. C).

3. Hook the front of the rail onto the holder and press down until

it engages and is fixed level in place in the appliance once

more (fig. D).

Each set of rails only fits on one side.

$

%

%

$

'

&

Advertising