Audiovox ONYX - Manual (Page 10)

18 19
Vehicle Installation
Installing the Vent Mount:
1 Locate a vent with horizontal
louvers sturdy enough to hold your
PowerConnect Vehicle Dock and radio .
2 If the vent louvers in your vehicle
are recessed, you may need to use
the longer vent clamps with the Vent
Mount . If so, remove the shorter vent
clamps and install the longer ones
into the Vent Mount . Be sure to observe the orientation of the vent
clamps as shown .
3 Push the Vent Mount onto the vehicle vent as shown (1) until it
hooks on the rear of the vent louver (2) .
4 Rest the foot against the bottom of the vent (2), and adjust the
tilt of the Vent Mount by repositioning the foot to a different
adjustment hole (3) .
To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .
PUSH
Dash
Vent
Louver
Foot
Vent
Vent
Dash Dash
HOOKED
TILT
ADJUSTMENT
HOLES
1 2 3
Slide Short Vent Clamps Out Remove End Cap
Slide Extended Vent Clamps In Replace End Cap
Extended Vent Clamps
Short Vent
Clamps