Philips Robust Collection Robot de cuisine - Manual (Page 8)

8
5 When you use one of the discs, add the ingredients through the
feeding tube and push them down with the pusher.
6 Press the speed button that corresponds to the accessory in the
bowl. Press speed 1 for the balloon beater, discs and kneading
accessory and press the blade unit button for the blade unit.
7 When you have finished processing, press button 0.
Feeding tube and pusher
- Use the feeding tube to add liquid and/or solid ingredients (Fig. 4).
- Use the pusher to push solid ingredients down the feeding
tube. (Fig. 5)
You can also use the pusher to close the feeding tube. This prevents
ingredients from escaping through the feeding tube.
Blade unit
You can use the blade unit to chop, mix, blend or puree ingredients.
1 Put the blade unit on the drive unit on the bottom of the
bowl (Fig. 6).
The cutting edges are very sharp. Do not touch them.
2 Put the ingredients in the bowl. Pre-cut large pieces of food into
pieces of approx. 3 x 3 x 3cm (Fig. 7).
3 Put the lid on the bowl (1) and turn it clockwise to close it
(2). Insert the pusher in the feeding tube to prevent spillage (Fig. 8).
4 Press the blade unit button (Fig. 9).
tips
- When you chop onions, press the pulse button a few times to
prevent the onions from becoming too finely chopped.
- Do not let the appliance run too long when you chop (hard) cheese
or chocolate. Otherwise these ingredients become too hot, start to
melt and turn lumpy.
- Do not use the blade unit to chop very hard ingredients like coffee
beans, turmeric, nutmeg and ice cubes, as this may cause the blade
to get blunt.
EnglisH 8
- The standard processing time for all chopping jobs is 30-60 seconds.
- If food sticks to the blade or to the wall of the bowl, switch off the
appliance and unplug it. Then use a spatula to remove the food from
the blade or from the wall of the bowl.
Discs
Never process hard ingredients like ice cubes with the discs.
The cutting edges of the discs are very sharp. Do not touch them.
1 Put the tool holder on the drive unit on the bottom of the
bowl (Fig. 10).
2 Place the desired disc on top of the tool holder (Fig. 11).
Note: Place the Julienne/French fries disc on top of the tool holder in such a
way that the longer plastic part in the centre of the disc points upwards.
3 Put the lid on the bowl (1) and turn it clockwise to close it
(2) (Fig. 12).
4 Put the ingredients in the feeding tube. (Fig. 13)
- Pre-cut large ingredients into chunks that fit in the feeding tube.
- Fill the feeding tube evenly for the best results.
- When you have to process a large amount of ingredients,
process small batches and empty the bowl between batches.
5 Press speed button 1.
6 Press the pusher lightly onto the ingredients in the feeding tube.
7 When you have finished processing, press button 0.
tip
- Do not use the discs to process chocolate. Only use the blade
unit for this purpose.
Kneading accessory
You can use the kneading accessory to knead yeast dough for bread
and pizzas.