MicraDigital P74847ea-A - Manual (Page 16)

Configuring Client TCP/IP
To access the Internet through the Wireless Router, you must configure the
network settings of the computers on your LAN to use the same IP subnet as
the Wireless Router. The default network settings for the Wireless Router are:
Gateway IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note: These settings may be changed to suit your network requirements,
but you must first configure at least one computer as described in this
chapter to access the Wireless Router’s web configuration interface.
See “Configuring the IEEE 802.11g Wireless Router” on page 20 for
information on configuring the Wireless Router.
The IP address of the connected client PC should be 192.168.2.x (where
x means 2–254). You can set the IP address for client PCs either by
automatically obtaining an IP address from the Wireless Router’s DHCP
service or by manual configuration.
12