MicraDigital P74847ea-A - Manual (Page 9)

5
Hardware Description
The Wireless Router can be connected to the Internet or to a remote site
using its WAN port. It can be connected directly to your PC or to a local area
network using any of the Fast Ethernet LAN ports.
Although access speed to the Internet is determined by your service type and
the modem type connected to the Wireless Router, data passing between the
devices connected to your local area network can run up to 100 Mbps over
the Fast Enternet ports.
The Wireless Router includes an LED display on the front panel for
system power and port indications that simplifies installation and network
troubleshooting. It also provides four RJ-45 LAN ports and one RJ-45 WAN
port on the rear panel.
• Four Ethernet ports for connection to a 10BASE-T/100BASE-TX Ethernet
Local Area Network (LAN). These ports can auto-negotiate the operating
speed to 10/100 Mbps, the mode to half/full duplex, and the pin signals to
MDI/MDI-X (i.e., allowing these ports to be connected to any network device
with straight-through cable). These ports can be connected directly to a
PC or to a server equipped with an Ethernet network interface card, or to a
networking device such as an Ethernet hub or switch.
• One RJ-45 port for connection to a DSL or cable modem (WAN). This port
also auto-negotiates operating speed to 10/100 Mbps, the mode to half/full
duplex, and the pin signals to MDI/MDI-X.
The following figure shows the components of the Wireless Router: