Boundless Technologies ADDS 3153 ASCII - Manual (Page 31)

20 Installation
Connection B: Host DTE
1. Enter the Setup menu. If the Aux port is to be assigned to Session 2, then switch
sessions (
Ctrl-Enter ( num )). Remain in session 1, if it is to be assigned to that
session.
2. In the Setup Quick (F1) menu, set the Host portion of the “Host/Printer”
selection to “Aux” without changing the current Printer option (“Aux/xxxx”).
The Printer will be set in another connection procedure if needed.
3. In the Ports (F6) menu, set the proper communications settings for the Aux
Baud, Aux Data Format, Aux Parity Check, Aux Recv, and Aux Xmt. See the
Setup chapter for more information on the individual settings.
Connection C: RS-232 with Modem
1. Follow all procedures of Connection A, step 1 through step 3.
2. If you are connecting to a modem, in the Ports (F6) menu, set the “EIA Modem
Control” parameter to “On”.
Connection D: RS-232-C with Modem
1. Follow all procedures of Connection B, step 1 through step 3.
2. If you are connecting to a modem, in the Ports (F6) menu, set the “Aux Modem
Control” parameter to “On”.
Connection E: Printer
1. In the Setup Quick (F1) menu, set the Printer portion of the “Host/Printer”
selection to “EIA” without changing the current Host option (“xxxx/EIA”).
The Host will be set in another connection procedure if needed.
2. Follow procedure of Connection A, step 3.
Connection F: RS-232-C Printer
1. In the Setup Quick (F1) menu, set the Printer portion of the “Host/Printer”
selection to “Aux” without changing the current Host option (“xxxx/Aux”).
The Host will be set in another connection procedure if needed.
2. Follow procedure of Connection B, step 3.
Connections G and H: Parallel Printer
1. Enter the Setup menu. If the PARA port is to be assigned to Session 2, then
switch sessions (
Ctrl-Enter ( num )). Remain in session 1, if it is to be assigned to
that session.
2. In the Setup Quick (F1) menu, set the Printer portion of the “Host/Printer”
selection to “Para” without changing the current Host option (“xxxx/ Para”).
3. Repeat this procedure if the parallel port is going to be used to print from both
sessions.
Only one session can access the parallel printer at one time.
If a print mode (Aux on, etc.) is on in both sessions, an error message will appear.
To disable a print mode in a session, press
Shift-Scroll Lock on a PC-style keyboard
or Shift-F3 on an ANSI keyboard.