Boundless Technologies ADDS 3153 ASCII - Manual (Page 62)

52 Setup
PROGRAM: F12
F1
Quick F2
Genrl F3
Displ F4
Kybd F5
Keys F6
Ports F7
Host F8
Print F9
Emul F10
Tabs F11
AnsBk F12
Prog Print
Exec
Param eters
Keys = F1 Program = FKey Key Dir = Host
Text: _________________________________________________________________________
_________________________________________________________________________
_________________________________________________________________________
_________________________________________________________________________
Label: _______________ Bytes Remaining: 0542
Choices
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12
Select
↑ → ↓ ← : Parameter Enter/S-Enter : Next/Prev Choice Exit: Setup Key
Program: [FKey, Sh-FKey, Ctrl-Fkey, Ctrl-Sh-Fkey, Edit Key, Sh-Edit Key]
Specify the type of key to be programmed—function or edit key in its normal or
shifted state.
When Fkey Speed is Fast in the EMUL (F9) menu, the Program options are
F/Key and Sh-F/Key .
Key Dir: [Comm Depend, Host, Printer, Printer & Host, Screen, Host & Screen,
Printer & Screen, All]
Select the destination of the contents of the function or edit key. Comm Dependent will
cause the direction of the key data to correspond to the “Comm Mode” of the current
session. For example, if the “Comm Mode” is
Full Block , the contents of the key will be
channeled to the screen only. If it were Full Duplex , then the contents would be sent to
the host only.
Text: An edit field which permits up to 255 characters. Once the overall text limit (up
to 542 characters) is reached, the terminal will beep and accept no more text. If the
text is deleted with the backspace key, the default code is no longer programmed.
Shift-Backspace will restore the default. See the Edit Fields section or “Fkey Speed”
in the Emulation section.