Philips PerfectCare Xpress Fer vapeur haute pression User Manual

Page 17

Advertising
background image

troubleshooting

This chapter summarises the most common problems you could

encounter with the appliance. If you are unable to solve the problem with

the information below, visit www.philips.com/support for a list of

frequently asked questions or contact the Consumer Care Centre in your

country.

Problem

Possible cause

Solution

The iron is plugged

in, but the soleplate

is cold.

There is a connection problem.

Check the mains cord, the plug and the

wall socket.

The iron does not

produce any steam.

There is not enough water in the

water tank.

Fill the water tank (see chapter ‘Using

the appliance’, section ‘Filling the water

tank’).

The iron is not hot enough to

produce steam.

Wait until the Smart light has stopped

flashing and lights up continuously.

You did not move the iron.

This iron is equipped with a motion

sensor and starts producing steam as

soon as it is moved.

The iron is not plugged in.

Plug in the iron to switch it on.

The iron does not

produce any steam

when moved.

Although the Auto Steam Sensor

technology covers a large number

of ironing movements, there may

still be some movements that do

not activate the sensor.

Press the steam trigger to start

steaming.

The iron continues to

steam when it is not

moved.

Because of the Auto Steam Sensor

Technology, steam may continue

to be produced for 1-4 seconds

to ensure good wrinkle removal at

the end of the ironing stroke. This is

normal.

If you want to avoid this, place the iron

on its heel.

The iron does not

produce Steam Boost.

You have used the Steam Boost

function too often within a very

short period.

Continue ironing in horizontal position

and wait a while before you use the

Steam Boost function again.

The iron is not hot enough.

Wait until the Smart light has stopped

flashing and lights up continuously.

Water droplets drip

onto the fabric during

ironing.

You have not closed the cap of the

filling opening properly.

Press the cap until you hear a click.

You have put a chemical in the

water tank.

Rinse the water tank and do not put any

perfume or any chemical in the water

tank.

The Smart light flashes

slowly.

The Safety Auto-off mode is active.

The iron has been switched to

standby mode(see chapter ‘Safety

Auto-off’).

To reactivate the iron, press the steam

trigger. The iron starts heating up again.

EnGlish

17

Advertising
This manual is related to the following products: