Black Box FX150A - Manual (Page 38)

39
LINESHARE PRO
factory-preset OFF, 0 0 *. To turn
the Extension Detection feature ON,
enter the programming mode and
press the following on your tone
phone:
1 Turn ON
0 Extension Detection
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[1] Home Routing
Home Routing operates only when
the Lineshare Pro is configured in
the secured mode.
This feature enables the Lineshare
Pro to hold the phone line after a
device disconnects from a call and
then route it to another port, or
“home.” Home is a temporary state
where the caller must enter an
access code, or a single-frequency
protocol tone, to access another
port.
When a call is rerouted home, the
amount of time that the caller has to
select another port is limited by the
Time at Home function. If the caller
does not enter a tone to access
another port during this time, the
Lineshare Pro disconnects the call.
The Home Routing feature is
factory-preset OFF, 0 1 *.
Turn this feature ON if you want to
allow access of multiple ports during
a single call in the secured mode.
To turn Home Routing ON, enter
the programming mode and press
the following on your tone phone:
1 Turn ON
1 Home Routing
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[2] Secured Operation
When the Lineshare Pro is in the
secured mode, the following features
are affected regardless of their
programming defaults or current
settings:
0 Extension Detection is OFF.
3 No Answer Cascade is OFF.
4 Answer/Disconnect Cascade is
OFF.
5 Pulse Transfer is OFF.
6 Open Line Notification is OFF.
7 Inbound Tone Transfer is OFF.
8 Ring Reduction is OFF.
9 Outbound Tone Transfer is OFF.