Black Box FX150A - Manual (Page 50)

51
LINESHARE PRO
• Port 1 6 rings
• Port 2 4 rings
• Port 3 4 rings
• Port 4 4 rings
To change the Rings Available to a
port to 20 rings, enter the
programming mode and press the
following on your tone phone:
8 Rings Available to the
FAX/MODEM Port
The selected port
2 0 The desired new number of
rings
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[8] [5] Rings to Answer Call
The Rings to Answer Call feature
determines the number of rings
received for a incoming phone call
before the Lineshare Pro answers.
The factory setting is one ring, to
permit the Lineshare Pro to answer
and transfer calls as quickly as
possible.
Under normal circumstances, it is
not necessary to change this setting.
However, if you have the phone
company’s “Caller ID” service, you
must set the Rings to Answer Call to
two rings.
This function has a range of 0 to
99 rings to answer a call. The Rings
to Answer Call is factory-preset to
one ring, 8 5 1 *.
To change the Rings to Answer
Call to two rings, enter the
programming mode and press the
following on your tone phone:
8 5 Rings to Answer Call
2 The desired new number of
rings
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[9] [9] [9] Reset to Factory Settings
To reset all features to their original
factory settings, enter the
programming mode and press the
following on your tone phone:
9 9 9 Reset to Factory Settings
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming