Black Box FX150A - Manual (Page 44)

45
LINESHARE PRO
NOTE
Settings in this function do
not affect the settings in the
Dual Tone Assignments
function.
Dual Tone Detection is factory-
preset as follows (the first number is
the corresponding port number; the
second number is 0 for OFF, or 1
for ON):
1 1 * (Port 1 = ON)
2 1 * (Port 2 = ON)
3 1 * (Port 3 = ON)
4 1 * (Port 4 = ON)
To change one port to ignore dual
tones, enter the programming mode
and press the following on your tone
phone:
2 2 Dual Tone Detection
The desired port selection (1-4)
0 Turn OFF
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
To change all ports to ignore dual
tones, enter the programming mode
and press the following on your tone
phone:
2 2 Dual Tone Detection
0 Select all ports 1 through 4
0 0 0 0 All ports OFF
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[2] [3] Protocol Tone Access Signal
Assignment
Protocol Tone Access Signal
Assignment allows you to define the
protocol tone access signal for each
of the ports. You can enter a
protocol tone access signal of 0-6 or
9 (see Table 5-3 for information).